High-quality, three-jaw special clutch with pressed aramid linings (commonly known as Kevlar) for your Puch moped with an E50 engine.
The plates of the centrifugal clutch feature larger lubrication holes, which minimize wear and reduce the weight to just 265 g. All metal parts are made of tough, high-quality S355 steel, which guarantees exceptional durability even under high loads.
We deliberately omitted retaining rings from the clutch plates and replaced them with 1.5 mm-thick washers. The entire E50 clutch is secured with a reinforcement plate and Torx countersunk screws, making the engine-clutch assembly 1 mm thinner overall. This also prevents the reinforcement plate from rubbing against the clutch bells.
Unlike woven aramid linings, these “sheet” clutch linings exhibit higher wear resistance but slip slightly more than the “woven” variant.
Note: This clutch is not suitable for kick-start engines.
You can find individual clutch linings as well as alternative tuning or racing clutches in the accessories section.
A quality product from the Austrian manufacturer A.S.P. - Puch Parts.
| Manufacturer | ASP |
| Material | Steel |
| Material addition | Aramid (colloquially known as Kevlar) |
| Recording type | Cone mounting |
| Number of jaws | 3 pcs |
| Number of springs | 6 pcs |
| Ø outside | 91.5 mm |
| Thickness | 21.5 mm |
| Area of application | Tuning, Racing |
| Puch | E50 |
Accessories & related products
HK clutch "supersport" | Puch Maxi S / N (E50)
Manufacturer: HK Clutches · Area of application: Cross · Area of application: High End · Area of application: Racing · Material addition: Aramid (colloquially known as Kevlar) · Recording type: Cone mounting · Number of jaws: 3 pcs · Number of springs: 3 pcs · Ø outside: 93.3 mm
EUR 416.60
ASP clutch springs reinforced 50 N/mm | Puch E50
Manufacturer: ASP · Spring design: Pressure spring · Ø wire: 1.8 mm · Number of components: 3 pcs · Area of application: Racing · Area of application: Tuning · Material: Spring steel · Ø inside: 4.6 mm · Ø outside: 8.2 mm · Spring rate: 50 N/mm · Total length: 27 mm
EUR 21.90
Explore categories from Clutch
Moped fans also bought
swiing® revival Stud Bolt Set M6x106 | Puch
Material: Steel · Surface: galvanized (blue) · Manufacturer: swiing® revival parts · Thread type: M6x1 (standard thread) · Total length: 106 mm · Drive: External hexagon · Nominal diameter (thread): 6 mm · Thread length: 13 mm · Thread length: 18.5 mm · Diameter: 5.9 mm · Width across flats: 10 mm · Alternative version of the Puch OEM number: 360.1.10.034.1
EUR 9.10
MBR clutch basket 18 teeth Racing straight | Puch E50
Manufacturer: MBR · Material: Steel · Toothing type: straight toothed · Number of teeth: 18 pcs · Recording type: Interlocking · Height: 49 mm · Ø Receptacle: 31 mm · Ø inside: 15 mm · Ø inside: 17 mm · Ø outside: 99.5 mm · Area of application: Tuning
EUR 226.60
Working late? Evening hours on Thursday until 20:00
